A channel mixer operating instructions and precautions
1, prior to use should be carried out with an air running test, the test should be preceded by the channel mixer all the strength of connections, the integrity of the oil volume reducer and electrical equipment, and then closing the master switch, which leads to power supply, empty running test.
2, empty running test requirements itemized test. Case is not that unusual sound, bearing file hair high fever reducer temperature helicopters and other undesirable phenomena, can be put into production.
3, in operation For scraping mixer trough wall materials, application of bamboo tool, must hand in order to avoid hand injury accident.
4 channel mixer to use the machine vibration is abnormal or an unusual strange noise, should be immediately stopped and checked.
5, the mixer using the load is not too large, a general to determine the load on the motor, 380V motor overloaded current when they are mixed, not to exceed 6 amps for the normal, such as overloading should immediately reduce the mixing capacity.
6, both ends of the agitator shaft seal should be kept clean to avoid the black material, deterioration, the mixing tank at both ends of the outside left square hole should be smooth, do not make it to plug in order to avoid anti-pressure, so that dirt infiltration axis, black tank material deterioration.
7, managers must be familiar with the technical performance of the channel mixer, internal structure, use the principle of control structures. Operation for a period not to leave the place of work, failure to prevent damage to the parts, in order to ensure safety in production as a precondition.
Two channel mixer maintenance instructions
A regularly check parts, 1-2 times a month, check the item for the various activities of the worm, the worm, bearings, shaft seal part of the rotating flexible wear, found that the defects should be repaired in time, in order to channel mixer can be used normally.
Lubrication: reducer lubrication with oil-immersed, its oil reserves must remain in the oil standard line, the oil must be kept clean. Such as frequently used to be every three months for a new oil replacement should reducer removable and washable cleaning, coupled with new oil.
Mixer electrical control components should be kept clean, sensitive, found that the fault should be repaired in time.
Once finished or laid off, you should remove the remaining material of the mixing tank, brush clear the machine part of the residual powder child. Such as disabled a long time, channel mixer must be all clean, and the tarpaulin cover.
5, the mixing paddle assembly and disassembly should be light demolition, stabilization installed light, to avoid distortion damage. |
Channel mixer instructions and routine maintenance